Description

1.1 This specification covers the chemical and mechanical requirements of three grades of carbon steel bolts and studs in sizes 1/4 in. through 4 in. The fasteners are designated by “Grade” denoting tensile strength and intended use, as follows:Grade Description, Grade A -Bolts and studs having a minimum tensile strength of 60 ksi and intended for general applications,Grade B -Bolts and studs having a tensile strength of 60 to 100 ksi and intended for flanged joints in piping systems with cast iron flanges, andGrade C -Replaced by Specification F 1554 Gr.36

1.1.1 The term studs includes stud stock, sometimes referred to as threaded rod.

1.2 This specification does not cover requirements for machine screws, thread cutting/forming screws, mechanical expansion anchors or similar externally threaded fasteners.

1.3 Suitable nuts are covered in Specification A 563. Unless otherwise specified, the grade and style of nut for each grade of fastener, of all surface finishes, shall be as follows: Fastener Grade and Size Nut Grade and Style A 1/ 4 to 11/2in.A, hex A over 11/2 to 4 in.A, heavy hex B, 1/ 4 to 4 in. A, heavy hex Nuts of other grades and styles having specified proof load stresses (Specification A 563, Table 3) greater than the specified grade and style of nut are also suitable.

1.4 The values stated in inch-pound units are to be regarded as the standard.

1.5 Supplementary Requirement S1 of an optional nature is provided, which describes additional restrictions to be applied when bolts are to be welded. It shall apply only when specified in the inquiry, order, and contract.

1.6 Terms used in this specification are defined in Terminology F 1789 unless otherwise defined herein.

Product Details

Published:

06/15/2007

Number of Pages:

5

File Size:

1 file , 95 KB

Redline File Size:

2 files , 180 KB